Pages

9/24/21

Paper Plate Halloween Wreath

 Check out my new Halloween wreath! The base is a paper plate.




---------


Paper Plate Halloween Wreath


Materials:


Steps: 


Cut the center out of a paper plate so that you have a ring. Then cut the Halloween papers into 1.5" x 8" strips. I used 25 strips for my completed wreath. 


Cut a V in the end of each strip, if desired. Glue the strips to the paper plate, letting a bit of the strip hang over the edge. Overlap the next piece slightly. 


Continue until all the strips are glued. Flip the wreath over. Use scissors to trim the excess paper so that the opening of the wreath is even. 


Decorate the wreath with papers and stickers. I cut the HAPPY HALLOWEEN strip from one of the patterned papers, then added the five stickers. 


Because it's made from a paper plate and strips of patterned paper, the finished wreath is very light and easy to hang. Mine is resting on a small Command hook.


I'm really happy with my new Halloween wreath!

1 comment:

I moderate comments, so you will not see yours appear right away. Please check back if you had a question; I promise to answer it as soon as I see it. Thank you for taking the time to comment!